Router Forums banner
Cancel

Pasquale Miranda

Jump to Latest Follow
1 - 6 of 6 Posts
PAAMiranda

· Registered
Joined
·
1 Posts
Discussion Starter · #1 ·
Hello everyone, I an new to CNC routing and decided to purchase a 3018 Pro for a beginning machine. I have it set up just fine, I created a G-code photo set it to the router but router just spins like it doesn't recognize the G-code. Any help for a beginner would be much appreciated.
 
old55

· Official Greeter
Ross
Joined
·
12,196 Posts
#2 · (Edited)
Welcome to the forum Pasquale. While I can’t help with your inquiry there are a number of experienced CNC users on the forum who will no doubt lend a hand.
 
Save Share
Reply Quote
MEBCWD

· Registered
Mike
Joined
·
3,960 Posts
#3 ·
Welcome to the Router Forums.
What design software are you using? Are you saving the gcode file using the correct post processor for the machine controller you are using?
 
Save Share
Reply Quote
jw2170

· Official Greeter
Joined
·
20,405 Posts
#5 ·
Welcome to the forum...
 
Save Share
Reply Quote
1 - 6 of 6 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
About this Discussion
5 Replies
6 Participants
Last post:
marecat3
Router Forums
A forum community dedicated to router and woodworking professionals and enthusiasts. Come join the discussion about different types of routing and routers, shop safety, finishing, woodworking related topics, styles, tools, scales, reviews, accessories, classifieds, and more!
Full Forum Listing
Explore Our Forums
New Member Introductions Tools and Woodworking General Routing Table-mounted Routing Show N' Tell
Top