Router Forums banner
1 - 3 of 3 Posts

·
Registered
Joined
·
8,958 Posts
That would be the one Herb... I was hoping that you were going to say you had one that was collecting dust.:frown:

I stupidly gouged one of the sides of the templates teeth which creates between a 16th" and 1/8th" gap on one of the joints. That's why I would like to replace it at a reasonable price. The least expensive one (Amazon) is a 1/3rd of the cost of the entire PC 4216 Jig. Maybe someone will re-gift one to me :laugh2: I'll work around it/with it until then.
Marco, for a quick fix until you can replace it, can you get some JB Weld and build up that gouge and file it smooth? I have used it before on filling and patching metal and it is outstanding. Here is the link there are a lot of different kinds.
Herb
https://www.jbweld.com/products?surface=228686
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top