Router Forums banner
1 - 1 of 5 Posts

· The Router Guys
791 Posts
rabuckner said:
hi, i just purchased a porter cable 890 series routerwith the fixed base and plunge base. my question is with the plunge base. after adjusting the depth of cut, and tightening the depth rod locking knob, i made several cuts and realized the depth was changing. i found that the depth rod will slip if you push very hard down on the router. any one have any ideas or suggestions for this problem.

thanks in advance
Remove the O-ring between the depth rod locking knob and the base should fix the problem.
1 - 1 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.