Router Forums banner
1 - 2 of 5 Posts

· Registered
2 Posts
Discussion Starter · #1 ·
hi, i just purchased a porter cable 890 series routerwith the fixed base and plunge base. my question is with the plunge base. after adjusting the depth of cut, and tightening the depth rod locking knob, i made several cuts and realized the depth was changing. i found that the depth rod will slip if you push very hard down on the router. any one have any ideas or suggestions for this problem.

thanks in advance
1 - 2 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.