[TheFlash]

Hey I have PC/Rockwell 6302 which seems to be similar to porter cable 690. I also have an old craftsman router table. The mounting holes dont seem to line up with the router I have.

Anyway to make this work? If not is there current table out there I could use?

Thanks!

 

[TheFlash]

Thanks for the reply. Updated my profile by the way lol.

The top kinda looks like it is cast as it has ridges in it. So probably aluminum.

I was thinking of using the router as the template from underneath and drill the holes from underneath then countersink the holes from the top.

 

[TheFlash]

howdy Adam...
use the router's base plate as a template and mark hole locations/placement w/ a transfer punch..
if you have one hole that lines up yur golden...
other wise double stick the plate into your desired position...

NOTE:
as a plus, you'll be leaving the plate off of the base when you install the router...

Yeah sadly none of the holes line up with the router plate unless it's way off center.

Is there a good way to center it before I make the holes, besides eyeing it the best I can?

 

[TheFlash]

Hey got it mounted!