Router Forums banner
1 - 4 of 4 Posts

·
Registered
Joined
·
20 Posts
Discussion Starter · #1 ·
All went well thanks for all the ideas and help.made a new base for my panel raising bit and a coping sled.Made a couple sample cuts everything fit flush and square coulden't be happier.Used carpet tape to hold things in line while drilling piolet hole worked well on both the phenolic and the UHMW
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top