Router Forums banner
1 - 2 of 2 Posts

·
Registered
Joined
·
4 Posts
Discussion Starter · #1 ·
I'm looking for help on pin routing template making. First project will be jewerly box drawers. Bunch of scalloped holes instead of egg crate dividers. Any do's & don'ts that will keep me from re-inventing the wheel appreciated.
Thanks, Joe
Also, any printed titles too.
 

·
Registered
Joined
·
1,702 Posts
Well I can't help you much at this point other then to say we might be in this learning curve together as I just got one off ebay. The one I got was one sold by Shopsmith some years back and it is an overarm router with the pin on the table. I was able to find some insturctions on the Shopsmith site..... if this would interest you let me know an I'll tell you where to find it.

Ed
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top