Router Forums banner
1 - 1 of 9 Posts

· Registered
51 Posts
Hi Mike; I built my own stand for my planer and put wheets I bought from a local farm supply store. These are rubber wheels with brakes on them. I started with 1 1/2" wheels but later upgraded to 3". They roll much easier. I added a square frame to the discharge end of the table with another slightly (is that how you spell it?) larger frame to go arround it. I place a garbage bag in the smaller square and slide the larger one over it to catch chips. Makes clean up a lot faster but still misses a lot. This system makes it easy to change the bag, tie the full one and toss it. Hope some of these ideas help. Good luck.
1 - 1 of 9 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.