Router Forums banner
1 - 1 of 1 Posts

·
Registered
Joined
·
20 Posts
I have absolutely no idea if _you'd_ ever use a plunge base or not. I do, however, know that I use the plunge base quite a bit (yeah... pun intended). I even use the plunge base with the router motor installed in it!

Any time I'm doing any free hand routing that might call for starting a cut somewhere other than on the very outer edge(s) of a work piece I will use the plunge base (with motor installed). I don't like to "tilt plunge" to start routing a hole (or anything else) somewhere within the outer boundaries of a work area.
 
1 - 1 of 1 Posts
Top