Router Forums banner

Plunge springs removed from Elu MOF 177e?

2413 Views 11 Replies 6 Participants Last post by  DaninVan
Hey y'all,

Long time lurker/first time poster here :)
I just bought a Swiss-made Elu MOF 177e off eBay to go with my 1980s indestructible lightweight Ryobi. It seems to be in very good shape, looks like it spend its life under a router table and was well looked after.

There seems to be no spring action in the plunge - the rods slide with ease into the base, but don't spring back out. I assume they were removed to facilitate usage in a table. Does that sound plausible? The seller doesn't know about it, he never used the machine himself.

I looked up the MOF177/DW625 spares online and those springs are readily available for cheap. Do you guys know if I need to take the whole router apart from the top, or if there is a way to disassemble the base from the bottom?
1 - 1 of 12 Posts
If you can't find a manual (I didn't see anything in the router reference section) you'll have to just tinker around with it. Shouldn't be terribly hard but take lots of photos as you go. McMaster Carr has a great selection of springs, it's like yo can find something that will work.
1 - 1 of 12 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.