Router Forums banner
1 - 2 of 2 Posts

· Registered
Joined
·
3 Posts
Discussion Starter · #1 ·
Hi, went to my first wood show yesterday..Man o man my head is still spinning with all that neat stuff that i think, i need, to do the job right.:)
I bought a wood set for putting hard wood on the edge of plywood.I seen Bob use a birds mouth bit, I think. the folks at the show helped me to buy a bit that is supposed to touch 90% of the glue surface. They said it is a new bit that they make.the bit was at the Freud place but its not a freud. The plywood bit has a bearing on it ,when I lined up the bearing flush with the fence and took my 3/4 ply through it ,It dug in so much that there was a 1/16 to 1/8 gap on the other side of the fence between the work and the fence.. I didnt even try the hard wood bit because i dont think i am doing something right.. THE profile of the bit is square in the center and angles out to the edges.. Does any body know what this bit is called and How do I use it???????? thanks :confused:
 

· Registered
Joined
·
3 Posts
Discussion Starter · #4 ·
Doug,
Yes,
that was the bit the 60 degree bit set. http://pricecutter.com/product.asp_Q_pn_E_P16-4040

I guess the bearing was made for ... I dont know why the bearing is on the ply bit but not the hard wood bit .
I dont think I would have bought this bit if it takes this long to set up.
I am trying to KISS . Keep IT Simped Stupid mind set. I want to have more fun and enjoyment doing wood working than wasting wood. I will try it some more and see if its worth it. Thanks for the help.

Keith
Prov.27:17 :D
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top