Router Forums banner
1 - 9 of 9 Posts

· Registered
Joined
·
3 Posts
Discussion Starter · #1 ·
I have a question about my porter cable 371 compact belt sander, it runs well as it should, but recently, the spring for the tracking knob, is getting weak, I start the sander and use it and the belt goes into the metal edge and destroys the belt every time, what do I need to get the tracking knob off to put on a stiffer spring so it doesn't do that? I tried to twist off the knob, and at the end, it keeps turning without coming off, any ideas? Thx
 

· Official Greeter
Joined
·
20,392 Posts
Welcome to the forum.
 

· Super Moderator
John
Joined
·
6,975 Posts
Probably can find a parts here a lot of times they have a stomatic on the tool sure how to replace it welcome to the forum
 
  • Like
Reactions: minnesota.fatts327

· Super Moderator
John
Joined
·
6,975 Posts
Schmatic
 

· Super Moderator
John
Joined
·
6,975 Posts
1 - 9 of 9 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top