Router Forums banner
1 - 2 of 2 Posts

·
Registered
Joined
·
25 Posts
Discussion Starter · #1 ·
Just sold my Delta table saw set up that had a built in router table with a Triton router. I came across a really nice old Unisaw which also had a router table built in, but no router. I've located an old Porter Cable 5201 router, which I understand is no longer in production. I can't seem to find any information on it. My concern is purchasing any parts that might wear out, brushes etc. It's a 3 1/2 hp unit so it can cut through just about anything. I was thinking of setting it up in the table saw extension and using an MLCS speed control to get variable speeds out of it.

I've also come across a nice Bosch 1617 EVSPK that I can use for manual routing. Anyone know anything about the 5201 and if parts are available?

Thanks,
Joe
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top