Router Forums banner
1 - 1 of 1 Posts

·
Registered
Joined
·
62 Posts
It's been a while since I used my PC jig, but to state the obvious, the offset between pin and tail cuts is off. The only things that come readily to my mind are 1) you're using the wrong offset guide- there's a different one needed for the "mini" DT's than that used for standard DT's; 2) the offset guide might not be perfectly square (vertical) to the front (tail) board, such that the tail board isn't offset the right amount; 3) if your tail board is not centered between the template fingers, and you accidently flip it (inside to out) when assembling. Your tails look perfectly centered, so I doubt this last one is the cause. Just my $0.02
 
1 - 1 of 1 Posts
Top