Router Forums banner

1 - 3 of 3 Posts

·
Registered
Joined
·
11 Posts
Discussion Starter #1
I recently aquired appx. 50 router bits cheap. Many are rail/stile, joinery bits, and a lot of the common profile bits. Most of them are price cutter bits. Does anyone have experience with these bits? Any good? with the exception of a few, they are all sharp. Thans in advance.
Bob
 

·
Registered
Joined
·
32 Posts
I bought 3 green flush trim bits of the internet a while back and tossed them out after the bearings failed on their first use. Cost me more in material than the cost saving.
 
1 - 3 of 3 Posts
Top