Router Forums banner
1 - 2 of 2 Posts

·
Registered
Joined
·
1,995 Posts
When we moved here, the basement included simply stud walls. 3 or 4 of the rooms are sheet-rocked. For the remainder, I used 74- sheets of T-111 plywood.
My method was considerably more simplified: I used a hole saw to make one large hole at each opening, next; I used a bearing-guided template bit and from the exterior side - I followed the "template" (the framed opening). I've done this hundreds of times over the years - I've even used this method for building the cabinets in my office. It is super-fast and efficient, but there will be a lot of mess to clean-up!

Otis Guillebeau from Auburn, Georgia
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top