Router Forums banner
1 - 6 of 6 Posts

·
Marine Engineer
Doug
Joined
·
4,960 Posts
Discussion Starter · #1 ·
I have a MuscleChuck which I a quickly becoming quite fond of (The original Hitachi Router Collets weren't the best.....) and I am set up for 1/2 and 1/4 inch bits. I do have a handful of 1/8 inch bits that use a slip on collet adapter. Has anyone ever used these inside of the 1/4 inch collet adapter, or do I need to spend another $30 for the 1/8 inch MuscleChuck adapter?

Right now I have swapped back to the Hitachi collet when I need them, but that's a pain.
 

·
Retired Moderator
Joined
·
16,385 Posts
I haven’t had a chance to try any of my reducers yet but it shouldn’t make a difference if you are chucking a bit or a reducer.
 
  • Like
Reactions: kp91

·
Premium Member
Retired since June 2000
Joined
·
15,065 Posts
I don't fancy a reducer in a reducer, a precision chuck like the MUSCLECHUCK deserves a precision reducer.
 
  • Like
Reactions: JFPNCM
1 - 6 of 6 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top