Router Forums banner
1 - 1 of 1 Posts

· Registered
Joined
·
387 Posts
Hi: I would look at the instructions that came with the Rockler jig. It should give you the initial setting for the bit depth below your router base plate. I suggest that you get some scrap material the exact thickness of the material your going to use and make some sample joints to get it down to a good fit. Usually the bits are set a little bit deeper than the material that you are going to use. Hope this helps.. Woodnut65
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top