Router Forums banner
1 - 1 of 1 Posts

·
Registered
Joined
·
36 Posts
woodnut is right on target. The depth of the cut should be just (Maybe the thickness of a business card) deeper than the wood thickness that you are joining. This will leave things just a bit proud, and ready for sanding down after the joint is assembled. The tricky part is going to be the placement of the template to adjust your spacing. (Read the jig instructions carefully, and have some scrap to practice with.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top