Router Forums banner
1 - 1 of 1 Posts

· Registered
Joined
·
335 Posts
Discussion Starter · #1 ·
I am going to build a toolbox out of 1/2" Oak. The approximate size will be 22 long by 14 high and 12 deep. I want my dovetails to be on the 12" edges. With that thin of stock, half- blind joints will be too difficult. I will be using the through template on my Rockler jig. I have a generic (clear) plate for my Craftsman router and will use the bit and bushing from the Rockler jig. How deep will I set the depth of the bit? Any other advise for using this setup for the first time?
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top