[reds_21]

ok, new topic!!!!

i am attempting a project that requires a rabbet joint at the ends. now i have purchased the router bit from rockler and now have questions on how to apply the rabbet cut.

is it easier to do this cut on a mat or easier using a router table since the bit cutter is on the side compared to the cutters being at the bottom of the bit like a straight bit.

again, in desperate need of help!!!

shawn

 

[reds_21]

ok, so it doesn't matter weather it is done on a pad or a table?

i think i can do that just need to get the screws replaced on the table then!!