[jschaben]

I bought a craftsman ogee stile and rail bit . No instruction! I would like to make some doors. Can some one give instructions as to what pieces to router first and how to set the bits up

Hi Wally - Welcome to the forum
Normally you would want to route the rails (horizontal pieces) first. Then switch bits and use the pieces just routed to set up for the stiles. That, of course, is grossly understated.
Try this for a quicky introduction to R&S.
http://www.mlcswoodworking.com/shopsite_sc/store/html/smarthtml/graphics2/TM04-11railstile0911.pdf