Router Forums banner
1 - 1 of 16 Posts

· Registered
5 Posts
Craftsman ogee and stile and rail

I bought a craftsman ogee stile and rail bit . No instruction! I would like to make some doors. Can some one give instructions as to what pieces to router first and how to set the bits up
There is good information in the messages above from my original post. I like the idea of the one bit but have not used it. For me using a scrap piece of wood and getting stile and rail to fit like you want and keep them. Then when you need to set up again, just raise bit until it fits the pattern perfectly. Good luck, Jerry
1 - 1 of 16 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.