Joined
·
618 Posts
Bj,
I'm sure glad your here. I've found that clicking your name and searching your posts, will reveal more and better tips and tricks than a whole stack of woodworking books.
I use a sled for cope cuts so I need to adjust height when changing bits. But I'm building a mantle clock and wanted to use my r&s bits to make the door. Problem was, the frame was only going to be 1 1/2" wide. I was trying to think of a safe way to do it when I saw this post. Ripping the parts in half after routing is a simple solution that had not crossed my mind.
Thanks, Rusty
I'm sure glad your here. I've found that clicking your name and searching your posts, will reveal more and better tips and tricks than a whole stack of woodworking books.
I use a sled for cope cuts so I need to adjust height when changing bits. But I'm building a mantle clock and wanted to use my r&s bits to make the door. Problem was, the frame was only going to be 1 1/2" wide. I was trying to think of a safe way to do it when I saw this post. Ripping the parts in half after routing is a simple solution that had not crossed my mind.
Thanks, Rusty
