Router Forums banner
1 - 1 of 16 Posts

· Registered
1,955 Posts
I bought a craftsman ogee stile and rail bit . No instruction! I would like to make some doors. Can some one give instructions as to what pieces to router first and how to set the bits up
Welcome to the RouterForums, Wally.
One thing that might be helpful is to obtain some setup blocks, such as those from MLCS. While the dimensions of the Craftsman and MLCE ogee rail and stile bits may not be identical, they will be close, and they will help you set the two bits to the same height, within measurable tolerances.
MLCS Rail and Stile Carbide Tipped Router Bits 1
#9741 Ogee #8871

page 9 of the .pdf to which John (Jschaben) linked describes how to use these setup blocks.
1 - 1 of 16 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.