Router Forums banner
1 - 3 of 3 Posts

·
Registered
Joined
·
47 Posts
Discussion Starter · #1 ·
As the headline says, I’m looking for a bit set for 1.25” thick stock and 1/2” groove for plywood panels. Freud makes a nice set that adjust up to 1.25” but max groove width is only 3/8”. Any other manufacturer makes that?

BTW, it can be any style - shaker, ogee, etc.
 

·
Registered
Joined
·
47 Posts
Discussion Starter · #3 ·
Thanks, I will.
So far the only solution I found are “entry door bit sets”. The average stock thickness is around 1-1/2”. But such sets are both complicated and expensive. Here’s an example:
 
1 - 3 of 3 Posts
Top