Raised letter signs

Dleveque
You may want to drop a email or PM to Alan (mailee) for a tip or two looks like he has it down right.
see link below ▼

http://www.routerforums.com/showthread.php?t=2617&page=2&pp=10&highlight=mailee

Bj

For this application an upcut spiral bit would give a better finish. This type of bit has cutting edges on the end of the cutter where a straight cutter does not. Another consideration is providing enough support for your router base so it will ride evenly.

Dleveque

Just a add on Note***

Don't forget the Table Top Jig Saw/Scroll Saw, you can cut the letters or numbers out and then glue them in place. (with a good outside glue,T-Bond)

Or cut all the numbers and names as one item ,this will give it the look of free cut with a router . (Raised Letter Sign)

Bj