Ok, well some of you showed a lot of knowledge and interest when I was asking about an external speed controller, lets see how you do on panels LOL
I made my first raised panel door last night. I made the rails and stiles from poplar. The raised panels are 3/4" MDF. I routed the panel down until it fit in the groove.
Here is the question, how tight or loose should the panel be between the rails and stiles?
As it sits right now, the panel just fits in the groove. I've read a lot of articles that state not to glue the panel in as it's suppose to "float" between the rails and stiles for expansion and contraction from weather. I don't see how it's suppose to float if I had a hard time pushing it in there in the first place.
This is an older thread, you may not receive a response, and could
be reviving an old thread. Please consider creating a new thread.
A forum community dedicated to router and woodworking professionals and enthusiasts. Come join the discussion about different types of routing and routers, shop safety, finishing, woodworking related topics, styles, tools, scales, reviews, accessories, classifieds, and more!