Router Forums banner
1 - 1 of 1 Posts

1 Posts
Discussion Starter · #1 ·
I am going to purchase a panel raising and rail and stile router bits. I will be using them in a router table with a PC 7518 3.25 HP fixed base variable speed router.

The primary intended use is for making raised panel doors. Do you have any recommendations as to manufacturer, style, etc. Should I buy a matched set? Ones with back cutters, etc?

1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.