Router Forums banner
Cancel

re600 bearing problems

2134 Views 6 Replies 7 Participants Last post by  dutchman 46, 
C
Hello to the group. I am a long time woodworker and was browsing the internet on info on bearing noise with the re 600 ryobi router and came across this site. I thought I was out of luck in getting replacement bearings for my discontinued router until I read a few posts here.
Is it a simple matter to replace the bearings myself? If so does ryobi supply new bearings or must one go elsewhere to get them? Sources?
Dick
Reply
Save
Like
1 - 1 of 7 Posts
walowan
Well as long as it's a ryobi, I would just junk it...

I had a ryobi table saw that needed warranty work. I found the problem and askd ryobi for a part to replace the defective one...they sent me a used (not even cleaned up!) part as a replacement.

I will never own anothe piece of ryobi junk!
Reply
Save
Like
1 - 1 of 7 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Router Forums
A forum community dedicated to router and woodworking professionals and enthusiasts. Come join the discussion about different types of routing and routers, shop safety, finishing, woodworking related topics, styles, tools, scales, reviews, accessories, classifieds, and more!
Full Forum Listing
Explore Our Forums
New Member Introductions Tools and Woodworking General Routing Table-mounted Routing Show N' Tell
Top