Router Forums banner
1 - 1 of 1 Posts

·
Registered
Joined
·
8 Posts
Discussion Starter · #1 ·
I have: 3018, Candle and USGS, CAMBAM generated gcode from AutoCAD2020 DXF drawing.
PROBLEM:
1. I don't know how to adjust depth of cut.
2. I have Gcode for a two inch diameter circle. Candle set for inches. The resulting cut is 1/8 diameter circle. It does the same on UGCS.
3. I cant find out why.
4. Thanks in advance
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top