Router Forums banner

Recommendations for routing 1, 2 & 3mm thick Sintra

669 Views 0 Replies 1 Participant Last post by  signmania
I have a CNC router and need to rout stencils out of various thicknesses of Sintra (expanded foam pvc) sheets. I always get "fuzzy" edges that take forever to remove. Any recommendations on router bit (especially 1/8" diameter), rpm & feed rate?
1 - 1 of 1 Posts
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top