Router Forums banner
1 - 3 of 3 Posts

·
Registered
Joined
·
4 Posts
Discussion Starter · #1 ·
I have a reliant DD34 3/4" wood shaper from 1996. I need to convert it to take router bits. I have the needed router collets for this machine, but I can't remember how to attach them? Is there anybody who knows how to do this? Or perhaps has a manual.
Thanks!
 

·
Registered
Joined
·
4 Posts
Discussion Starter · #3 ·
Received manual

I have a reliant DD34 3/4" wood shaper from 1996. I need to convert it to take router bits. I have the needed router collets for this machine, but I can't remember how to attach them? Is there anybody who knows how to do this? Or perhaps has a manual.
Thanks!

I received a manual for the above shaper as an attachment via email from:

Woodtek Technical Dept.
Woodworker's Supply, Inc
[email protected]
[email protected]
1.800.545.9663

Although it doesn't show how to attach router bits, I was able to figure it out after I removed the spindle from the router.

jointer2
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top