Router Forums banner

Reluctant woodworker

2433 Views 14 Replies 7 Participants Last post by  randymoe
Hi folks!

My real hobby is old cameras, which turns out to be wood cameras in the end. I often find I need to make this or that and a router and a router table are most likely the cheapest, smallest and most efficient method of making wood camera parts.

I even want to make a large wood camera and there are several parts that must be machine accurate.

I was given an old Sears Craftsman Model 315 with a couple bits. I have never used a router, but I am handy with tools and even built a wood stringer and skin boat with a table saw and glue.

My camera insanity has me searching for ways to make two simple box bellows frames, 18" square with half lab joints. I actually can't decide whether to simplly do it with hobby shop wood and a chisel,:) as I need it now! If I already had a router table setup, I would use that.

So I will be here reading this great knowledge base.

Thanks for all this!
1 - 2 of 15 Posts
Welcome to the forum.

Do you still use glass plates?
A picture of a finished camera would be good, Randy.
1 - 2 of 15 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.