Your sofa table is 5' long and ??? wide and 3/4" thick I assume. The piece is bigger than the router so I would recommend using the portable router and rout the edges with a pilot bearing round over bit. Your slight drop is called the profile line. Good Luck with your routing project.
retired
first time on forum. i have made a router table, now am planning a sofa table 5' long x 3/4". i want to round off the edges with a slight drop from the top to the start of the roundover, about a 1/16". the question is would i be better off to rout freehand from the top of the board or use the router in the table.
1 - 2 of 2 Posts
1 - 2 of 2 Posts
- This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Router Forums
A forum community dedicated to router and woodworking professionals and enthusiasts. Come join the discussion about different types of routing and routers, shop safety, finishing, woodworking related topics, styles, tools, scales, reviews, accessories, classifieds, and more!
Full Forum Listing
Recommended Communities
