Router Forums banner
1 - 2 of 2 Posts

·
Marine Engineer
Doug
Joined
·
4,960 Posts
Thanks Doug, I was going to take it to work use my mill but ya that's probably good enough. Thanks again.
Is it a 3 hole or 4 hole pattern? My Porter cables are 3 hole, so it's the screw hole circle diameter, holes spaced every 120 degrees. I laid it out with a protractor and scale the first time, the second time I used the base plate and a transfer punch. If you are going to be using template guides you really have to make sure you are centered on the plate when you drill.
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top