[CanuckGal]

Some of you may have this model table saw and should be aware of the recall. The information is available here:
http://www.ridgid.com/Download/R4511_PR.pdf

It sounds like there is a problem when using a stacked dado set, the blade may come off. :bad:
Not good!

 

[AxlMyk]

I'll pass the word on other forums.

 

[jschaben]

Some of you may have this model table saw and should be aware of the recall. The information is available here:
http://www.ridgid.com/Download/R4511_PR.pdf

It sounds like there is a problem when using a stacked dado set, the blade may come off. :bad:
Not good!

Recall said no injuries reported. Must not have been counting underwear, mine would have been totalled:help:

 

[BigJimAK]

No kidding, John. About the time the shaft came apart and the cutters (hopefully) imbedded themselves in the ceiling like martial arts throwing knives, I'd of lost it!

 

[AxlMyk]

Or came out the bottom of the saw and did a hop, skip, jump between your legs.

 

[sheridan]

Really on R4511? I have to check.

 

[fishhawk_1750]

Thanks for the info. I checked this out with Ridgid and found that saws manufactured during a specific run were affected. My saw was made after the problem was corrected. I feel much better now about using my saw.
Thanks again,
Fishhwk_1750