Router Forums banner
1 - 1 of 1 Posts

151 Posts
Discussion Starter · #1 ·
ok, next question on dovetail jigs via rockler

i have the jig set up and ready to go and on the instructions i notice that it calls out for lumber from 3/8" all the way to 3/4" thick. so your telling me that i can only use minimum of 3/8" thick? what if i wanna use something smaller than 3/8" or bigger than 3/4". is there anything that can be done?

1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.