Router Forums banner
1 - 1 of 19 Posts

· Registered
7,196 Posts
Way back I found out my bits climbed because they bottomed out - real old Ryobi router. Was told if I raised my bit about 1/8" they would not climb, which proved to be true. So, now I just let the bits go as deep as they can go, raise them up about 1/8" or so, tighten the collet, and no problems.
  • Like
Reactions: JFPNCM
1 - 1 of 19 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.