Router Forums banner
1 - 1 of 1 Posts

·
Registered
Joined
·
413 Posts
If it's like mine, you just unscrew the ½" collet until it comes off and screw on the ¼" collet. The nut and collet are combined. Unless the ¼" is an insert for the ½" collet, in which case I don't know what I'm talking about. Check the maual that came with the router. No biggie. :)

To your second question, I use a Mastercraft router and a ryobe table. With the router fully raised I can turn the collet nut and replace the bit without removing the router from the table. Try it and see. This stuff is surprisingly hard to break.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top