Router Forums banner
1 - 3 of 3 Posts

·
Registered
Joined
·
5 Posts
Discussion Starter · #1 ·
Had some difficulty making the juice groove on a round cutting board, until I came up with fixture shown in thumbnail, which uses a router, and two ball bearings to guide the cutting board.

Arrow on fixture shows direction to rotate the cutting board so that spinning router bit does not push it away from the ball bearings.

 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top