Joint just one edge then use table saw to rip the edges parellel 1/16" larger than you want. Last operation is to joint the ripped edge smooth and remove the 1/16".
Router Jointing
Here's another newbie question. I have been using a table mounted router to do some jointing. The outfeed part of the fence is 1/16" proud of the infeed.
I have been jointing both edges of the boards. The problem is that I sometimes wind up with two edges that are not parallel. Is there some way to minimize or eliminate this?
Drick
I have been jointing both edges of the boards. The problem is that I sometimes wind up with two edges that are not parallel. Is there some way to minimize or eliminate this?
Drick
1 - 2 of 2 Posts
1 - 2 of 2 Posts
- This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Router Forums
A forum community dedicated to router and woodworking professionals and enthusiasts. Come join the discussion about different types of routing and routers, shop safety, finishing, woodworking related topics, styles, tools, scales, reviews, accessories, classifieds, and more!
Full Forum Listing
Recommended Communities
