Router Forums banner
1 - 9 of 9 Posts

·
Registered
Joined
·
4 Posts
Discussion Starter · #1 ·
Hello All,

I recently acquired a Kreg Precision Router Table System with the PRS1020 top. I am looking at getting a router lift for it that will drop in without making modifications to the table top. Any recommendations?

Thanks!
 

·
Registered
Joined
·
4 Posts
Discussion Starter · #3 ·
Terry,

The plate size is 9 1/4" x 11 3/4" (235mm x 298mm), not sure of the corner radius.

I was going to contact Kreg for a list of compatible lifts, but wanted to first reach out to the forum for recommendations from users with the same table and what lift they had.

I was looking at the Woodpeckers Precision Router Lift V2 and Jessem Rout-R-Lift II, both appear to fit but wanted to get thoughts from the knowledge of the forum.

Bill
 

·
Registered
Joined
·
199 Posts
I have a Jessum master lift II in a home made top, and a Rockler router lift in a Rockler top. Can’t comment on Kreg table specifically.

9 1/4 x 11 3/4 is the most common sized lift, but Rockler and their Bench Dog brand are one of the odd balls at 8 1/4 x 11 3/4. So long as you get a lift compatible with your router and table opening I don’t think you can really wrong. Jessum, Incra, and woodpecker seem to me to be closely related and you can’t go wrong with any of them.



In woodworking there is always more then one way to accomplish something.
 

·
Registered
Joined
·
2,603 Posts
Terry,

The plate size is 9 1/4" x 11 3/4" (235mm x 298mm), not sure of the corner radius.

I was going to contact Kreg for a list of compatible lifts, but wanted to first reach out to the forum for recommendations from users with the same table and what lift they had.

I was looking at the Woodpeckers Precision Router Lift V2 and Jessem Rout-R-Lift II, both appear to fit but wanted to get thoughts from the knowledge of the forum.

Bill
I have the Woodpecker lift in a Woodpecker table and like but I am sure the Jessem is just as good.
 
1 - 9 of 9 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top