Router Forums banner
1 - 1 of 8 Posts

· Registered
107 Posts
I opted to position my router lift centered 1” further away from the fence (as seen in the picture below) when the fence is furthest to the right of the TS blade. For me, in my shop, this was the optimum way to have both tools integrated. Also, center of plate is 12” from the edge of the table, leaving room for a miter track when/if I decide I need to add it.

Sent from my iPad using Tapatalk
1 - 1 of 8 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.