Router Forums banner
1 - 1 of 1 Posts

· Banned
Joined
·
12,004 Posts
Larry, although they perform many of the same functions there is a world of difference. It's a safe bet you wouldn't want to throw a shaper into your vehicle to run and do a repair for a friend. By the same token you wouldn't want to run router bit's non-stop all day long for heavy commercial production. For the average person a router and table are the cost effective solution. Production shops benefit from the shapers longer lasting cutters and greater power. Most shapers cost substantially more than a good router and table set up.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top