Router Forums banner
1 - 1 of 6 Posts

· Registered
23,784 Posts
Hi kbarry

Most routers can go down to 1/4" easy but to go up to 1/2" well that's different .
Can you PLEASE post the make and model number of your router and will some luck someone may know if you can get adapter but don't bet on it.
One small note,,,,when you make raise panel doors you should use a 3HP+ router with a speed control.
One more small note, you can find 1/4" shaft panel bits but I don't recommend them but that would be one way to work around it.

Bj :)
1 - 1 of 6 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.