Birchwood
Just one more way.See Below ▼
Or just drill and tap a 1/4-20 hole in the base plate (use a #7 drill bit) to the right of the router bit (about 1.125") then get a 1/4-20 x 3" bolt, then cut off some so the threads form the bolt ,so you have about 1/2" of good threads then cut the head off so you end up with a pin that's 1 3/8" long, round the top just a bit.
If have a brass bolt use it if not just a steel one until you get by ACE or Home Depot to get a brass bolt.
Bj
▼
Look for a small pin jig ▼ on link below
http://www.routerforums.com/showthread.php?t=2532
Just one more way.See Below ▼
Or just drill and tap a 1/4-20 hole in the base plate (use a #7 drill bit) to the right of the router bit (about 1.125") then get a 1/4-20 x 3" bolt, then cut off some so the threads form the bolt ,so you have about 1/2" of good threads then cut the head off so you end up with a pin that's 1 3/8" long, round the top just a bit.
If have a brass bolt use it if not just a steel one until you get by ACE or Home Depot to get a brass bolt.
Bj
▼
Look for a small pin jig ▼ on link below
http://www.routerforums.com/showthread.php?t=2532
