Router Forums banner
1 - 1 of 1 Posts

· Registered
Joined
·
1 Posts
Discussion Starter · #1 ·
Hello forum team, I am in the middle of designing a project that includes a sliding Tambour door, using specialty router bits. I need help in routing out a curved groove for the tambour door to slide in. If some one from the forum can provide some insight, it would bring one step closer in my design plans.:thank_you2:
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top