Router Forums banner

1 - 3 of 3 Posts

·
Retired Moderator
Joined
·
2,093 Posts
Discussion Starter · #1 ·
I have crown molding bits and want to know what I should set my router rpm on full speed or should I run them a little slower. :D
 

·
Registered
Joined
·
1,702 Posts
Glenmore said:
I have crown molding bits and want to know what I should set my router rpm on full speed or should I run them a little slower. :D
A lot has been said on another thread
www.routerforums.com/showthread.php?t=85

I think slower might be better at least until you get the feel of making the cuts, and if you have a 3 1/2 bit you WILL need to run it slower.

Ed
 
1 - 3 of 3 Posts
Top