Joined
·
2,605 Posts
Have you thought about using your table saw to flatten the board? Put the convex side down on the TS and saw a groove about 2/3 through the board. After that put some glue in the groove and clamp it down on a flat service. It should come out after the glue dries pretty flat.
You might have to shim the board on either side to keep it from rocking while sawing. You could use double stick tape to attach the shims. If you decide to do it let me know how it came out.
You might have to shim the board on either side to keep it from rocking while sawing. You could use double stick tape to attach the shims. If you decide to do it let me know how it came out.
